LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2020 >> Acadia AT4 >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Instrument Panel And Console Trim >> Repair Instructions >> Instrument Panel Knee Bolster Replacement >> Removal Procedure

Removal Procedure

  1. GM4430512Courtesy of GENERAL MOTORS COMPANY

    Front Side Door Sill Garnish Molding (1) - Remove - Front Side Door Sill Garnish Molding Replacement

  2. GM4381436Courtesy of GENERAL MOTORS COMPANY

    Instrument Panel Insulator-Left Side (2) - Remove - Instrument Panel Insulator Replacement - Left Side (Left Hand Drive) , or Instrument Panel Insulator Replacement - Left Side (Right Hand Drive) 

  3. GM4403805Courtesy of GENERAL MOTORS COMPANY

    Instrument Panel Cluster Trim Plate (1) - Remove - Instrument Panel Cluster Trim Plate Replacement 

  4. GM4421600Courtesy of GENERAL MOTORS COMPANY

    Instrument Panel Lower Airbag - Driver Side (2) - Remove - Instrument Panel Lower Airbag Replacement - Driver Side

  5. GM4381679Courtesy of GENERAL MOTORS COMPANY

    Instrument Panel Outer Trim Cover - Left Side (1) - Remove - Instrument Panel Outer Trim Cover Replacement 

  6. GM4393979Courtesy of GENERAL MOTORS COMPANY

    Front Floor Console Trim Plate (1) - Remove - Front Floor Console Trim Plate Replacement (GMC) 

  7. GM4406520Courtesy of GENERAL MOTORS COMPANY

    Pull down the hood primary latch release cable handle. (1)

  8. Disconnect the data link connector. (2)
  9. Instrument Panel Knee Bolster Bolt (3) - Remove [8x]
  10. GM4406523Courtesy of GENERAL MOTORS COMPANY

    Use a plastic trim tool if necessary.

  11. Instrument Panel Knee Bolster (1) - Remove
  12. Disconnect all electrical connectors.
  13. Transfer components as necessary.
scientia non olet · About LEMON Manuals