Conditions for Running the DTC
WARNING: This page is about a different car, the 2022 Cadillac CT4. However, it is still accessible from the selected car via links, so may be relevant.
- DTC P2534 = Not set
- DTCs related to the following system/component = Not Set
- B14A Automatic Transmission Output Speed Sensor
- B14C Automatic Transmission Input Speed Sensor
- B14DA Automatic Transmission Intermediate Speed Sensor 1
- B14DB Automatic Transmission Intermediate Speed Sensor 2
- B303 Transmission Range Sensor
- Transmission Control Solenoid Valves - Circuit DTCs
- Battery Voltage = Greater than 9 V
- Engine = Running
- High Side Driver 1, 2 = On
- Ignition and Start Signal = 9 to 32 V
- Ignition and Start Switch Signal = On
- Scan Tool Control Function = Not Activated
- Transmission Range = D, L or M
- One of the following conditions listed below is true:
- Accelerator Pedal Position = Greater than 0.5%
- Engine Speed = Greater than 1, 000 RPM
- Transmission Input Speed = Greater than 349 RPM
- Transmission Output Shaft Speed = Greater than 35 RPM
Frequency the DTC runs = Continuously - After the running conditions are met