LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2019 >> Terrain SL >> Repair and Diagnosis >> External Pages >> Different car >> Section 360 (Automatic Transmission - 10L60 (MQA) Or 10L80 (MHU) - Diagnostic Information And Procedures (2 Of 2)) >> Diagnostic Information and Procedures >> DTC P189C >> Circuit/System Testing

Circuit/System Testing

WARNING: This page is about a different car, the 2022 Cadillac CT4. However, it is still accessible from the selected car via links, so may be relevant.
    NOTE:

    It may take up to 2 min for all vehicle systems to power down before an accurate ground or low reference circuit continuity test can be performed.

  1. Ignition/Vehicle - Off
  2. Disconnect the electrical connector.
    • K20 Engine Control Module
    • K71 Transmission Control Module
  3. Test for less than 1 V between the test points: Serial Data circuit terminal 31 @ K71 Transmission Control Module & The other end of the circuit
    • If greater than 1 V 

      Repair the short to voltage on the circuit.

    • Go to next step: If less than 1 V 
  4. Test for infinite resistance between the test points: Serial Data circuit terminal 31 @ K71 Transmission Control Module & Ground
    • If less than infinite resistance 

      Repair the short to ground on the circuit.

    • Go to next step: If infinite resistance 
  5. Test for less than 10 ohms between the test points: Serial Data circuit terminal 31 @ K71 Transmission Control Module & The other end of the circuit
    • If greater than 10 ohms 

      Repair the open/high resistance in the circuit.

    • Go to next step: If less than 10 ohms 
  6. Replace the component: K71 Transmission Control Module
  7. Verify the DTC does not set.
    • If the DTC sets 

      Replace the component: K20 Engine Control Module

    • Go to next step: If the DTC does not set 
  8. All OK.
scientia non olet · About LEMON Manuals