Conditions for Running the DTC

P0741

• DTC P0101 - P0103, P0106 - P0108, P0171, P0172, P0174, P0175, P0201 - P0208, P0300 - P0308, P0401, P042E, P0716, P0717, P0722, P0723, P0742, P2763, P2764 = Not set
• Accelerator Pedal Position = Greater than 8%
• Accelerator pedal position signal = Valid
• Engine Speed = 400 to 7, 500 RPM - For greater than 5 s
• Engine Torque = Greater than 50 Nm (37 lb ft)
• Engine Torque Signal = Valid
• Gear Ratio = Between:
  • 2nd Gear Ratio = 2.75 to 3.17
  • 3rd Gear Ratio = 1.78 to 2.04
  • 4th Gear Ratio = 1.35 to 1.55
  • 5th Gear Ratio = 0.93 to 1.07
  • 6th Gear Ratio = 0.70 to 0.80
• Ignition Voltage = 9 to 32 V
• Torque Converter Clutch Pressure Command = Greater than 500 kPa (73 PSI) - For greater than 2 s
• Transmission Fluid Temperature = -7 to 130°C (20 to 266°F)
• Power Take-Off = Off

Frequency the DTC runs = Continuously - After the running conditions are met

P0742

• DTC P0101 - P0103, P0106 - P0108, P0171, P0172, P0174, P0175, P0201 - P0208, P0300 - P0308, P0401, P042E, P0716, P0717, P0722, P0723, P0741, P2763, P2764 = Not set
• Accelerator Pedal Position = 10 to 75%
• Engine Speed = 400 to 7, 500 RPM - For greater than 5 s
• Engine Torque = Greater than 35 Nm (26 lb ft)
• Ignition Voltage = 9 to 32 V
• Torque Converter Clutch = Off
• Transmission = Forward Gear
• Transmission Fluid Temperature = -7 to 130°C (20 to 266°F)
• Vehicle Speed = Greater than 1 km/h (0.6 MPH)

Frequency the DTC runs = Continuously - After the running conditions are met