Circuit/System Testing
WARNING: This page is about a different variant/trim than selected.
- Ignition - On / Vehicle - In Service Mode
- Perform the scan tool control function: EVAP Purge/Seal - Not Venting
- Engine - Idling
- Verify the scan tool parameter: Fuel Tank Pressure Sensor = Less than 1.7 V - For 90 s
- If 1.7 V or greater
Replace the component: Q12 Evaporative Emission Purge Solenoid Valve
- Go to next step: If less than 1.7 V
- If 1.7 V or greater
- All OK.