Component Testing
- Ignition OFF, remove the Primary Fuel Level Sender.
- Sweep the Fuel Level Sensor through its full range of motion while measuring resistance between the signal terminal 5 and the low reference terminal 6.
- Test for a minimum resistance value of 37-43 Ω and a maximum value of 245-255 Ω without any spikes or dropouts.
- If minimum resistance is not 37-43 Ω, maximum resistance is not 245-255 Ω, or if there are any spikes or dropouts
Replace the Fuel Level Sensor.
- Go to next step: If minimum resistance is 37-43 Ω, maximum resistance is 245-255 Ω, and if there are no spikes or dropouts
- If minimum resistance is not 37-43 Ω, maximum resistance is not 245-255 Ω, or if there are any spikes or dropouts
- All OK.