LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2018 >> Terrain Denali, FWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 7 (Engine Controls And Fuel - 1.5L (LYX) - Diagnostic Information And Procedures (P0351 - P26C8) And Symptoms) >> Diagnostic Information And Procedures >> DTC P2635: Fuel Pump Flow Performance >> Repair Verification

Repair Verification

WARNING: This page is about a different variant/trim than selected.
  1. Install any components that have been removed or replaced during diagnosis.
  2. Perform any adjustments, programming or setup procedures that are required when a component is removed or replaced.
  3. Clear the DTCs with a scan tool.
  4. Turn OFF the ignition for 60 s.
  5. Operate the vehicle within the Conditions for Running the DTC.
  6. Command the Fuel Pressure to 300 kPa (43.5 PSI) using the scan tool Control Function: Fuel Pressure Increase/Decrease.
  7. Verify the scan tool parameter: Fuel Pressure Sensor & Desired Fuel Pressure are within 45 kPa (6.5 PSI) of each other at 300 kPa (43.5 PSI) request.
    • If greater than 45 kPa (6.5 PSI) 

      Refer to Circuit/System Testing.

    • Go to next step: If less than 45 kPa (6.5 PSI) 
  8. Command the Fuel Pressure to 400 kPa (58 PSI) using the scan tool Control Function: Fuel Pressure Increase/Decrease.
  9. Verify the scan tool parameter: Fuel Pressure Sensor & Desired Fuel Pressure are within 60 kPa (8.7 PSI) of each other at 400 kPa (58 PSI) request.
    • If greater than 60 kPa (8.7 PSI) 

      Refer to Circuit/System Testing.

    • Go to next step: If less than 60 kPa (8.7 PSI) 
  10. All OK.
scientia non olet · About LEMON Manuals