Component Testing
WARNING: This page is about a different variant/trim than selected.
Static Test
- Ignition Off, disconnect the harness connector at the Q40 turbocharger bypass solenoid valve.
- Test for 10 - 14 Ω between the control terminal 2 and the Ignition terminal 1 of the Q40 turbocharger bypass solenoid valve.
- If not between 10 - 14 Ω
Replace the Q40 turbocharger bypass solenoid valve.
- Go to next step: If between 10 - 14 Ω
- If not between 10 - 14 Ω
- All OK
Dynamic Test
- Install a 15 A fused jumper wire between the ignition terminal 2 of the Q40 turbocharger bypass solenoid valve and 12 V. Install a jumper wire between the control terminal 1 and ground.
- Verify the Q40 turbocharger bypass solenoid valve plunger retracts.
- If the plunger does not retract.
Replace the Q40 turbocharger bypass solenoid valve.
- Go to next step: If the plunger retracts.
- If the plunger does not retract.
- All OK