LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2018 >> Terrain Denali, FWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 7 (Engine Controls And Fuel - 1.5L (LYX) - Diagnostic Information And Procedures (P0351 - P26C8) And Symptoms) >> Diagnostic Information And Procedures >> DTC P16A7, P16AF, Or P16B3: Engine Controls Ignition Relay >> Circuit/System Verification

Circuit/System Verification

WARNING: This page is about a different variant/trim than selected.
    NOTE:
    • A short to voltage on other components may cause DTC P16B3 to set. If any other DTC is set, diagnose that DTC first.
    • If you were sent here from Engine Cranks But Does Not Run, proceed to Circuit/System Testing.
  1. Ignition ON, observe the scan tool DTC information. Verify DTC P16A7, P16AF, or P16B3 is not set.
    • If any of the DTCs are set 

      Refer to Circuit/System Testing.

    • Go to next step: If none of the DTCs are set 
  2. Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
    • If the DTC sets 

      Refer to Circuit/System Testing.

    • Go to next step: If the DTC does not set 
  3. All OK.
scientia non olet · About LEMON Manuals