Installation Procedure
WARNING: This page is about a different variant/trim than selected.
- Position the transmission rear mount strut bracket (3) to the transmission.
- Install the two transmission rear mount strut bracket to power transfer unit bolts (1, 2) first and tighten to 100 N.m (74 lb ft) plus 60 - 75 degrees.
- Install the two transmission rear mount strut bracket to transmission bolts (4, 5) and tighten to 100 N.m (74 lb ft) plus 60 - 75 degrees.
- Install the transmission mount strut. Transmission Mount Strut Replacement (All Wheel Drive)
CAUTION:
Refer to Fastener Caution .