Installation Procedure
WARNING: This page is about a different variant/trim than selected.
- Install the transmission range selector lever (2).
- Install the transmission range selector lever nut (1) and tighten to 30 N.m (22 lb ft).
- Install the transmission range selector lever cable (2) to the cable bracket.
- Connect the transmission range selector lever cable terminal (1) to the transmission manual shift lever pin.
- Check the range selector cable adjustment. Refer to Range Selector Lever Cable Adjustment .
- Install the battery tray. Refer to Battery Tray Replacement .
WARNING:
Hold the transmission range selector lever while removing or installing the lever retaining nut. Failure to hold the lever can cause damage to the transmission internal park system components which could allow the vehicle to roll when placed in the park position.
CAUTION:
Refer to Fastener Caution .
WARNING:
After installing the transmission range selector shift cable, pull up and push down on ALL connections to verify that the connections are fully seated and properly engaged. Failure to perform this task can result in the vehicle not being able to shift into PARK causing potential vehicle damage and bodily injury.