Auxiliary Fluid Accumulator Replacement (Terrain)

WARNING: This page is about a different variant/trim than selected.

Fig 1: Auxiliary Fluid Accumulator

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
WARNING: The automatic transmission fluid accumulator may be pressurized greater than 120 psi (827 kpa) and fluid may be hot. When servicing accumulator, key must be OFF for a minimum of 10 minutes. Do not open bleeder screw until instructed to do so or personal injury may result. Preliminary Procedures Battery Tray Replacement Range Selector Actuator Replacement
1	Auxiliary Fluid Accumulator Pipe Bolt [2x] CAUTION: Refer to Fastener Caution . Tighten 22 N.m (16 lb ft)
2	Auxiliary Fluid Accumulator Pipe
3	Auxiliary Fluid Accumulator Bolt [3x] Tighten 22 N.m (16 lb ft)
4	Auxiliary Fluid Accumulator Assembly Procedures Disconnect/connect the electrical connector. Replace seals as necessary. Check the transmission fluid level. Transmission Fluid Level and Condition Check