LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2018 >> Terrain Denali, FWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Engine Mechanical - 1.6L (LH7) Diesel) >> Repair Instructions - On Vehicle >> Crankshaft Rear Oil Seal Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Remove the crankshaft position sensor reluctor ring. Refer to Crankshaft Position Sensor Reluctor Ring Replacement .
    2. Fig 1: Crankshaft Rear Oil Seal And Removers
    GM3275482Courtesy of GENERAL MOTORS COMPANY
  2. Punch a bore into the crankshaft seal, use a suitable tool.
  3. Install the EN-6624  remover (2) into the oil sealing ring (1).
  4. Install the GE-328-B  remover (3) to the EN-6624  remover (2).
  5. Remove the crankshaft rear oil seal, with the GE-328-B  remover.
scientia non olet · About LEMON Manuals