LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2018 >> Terrain Denali, FWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Engine Mechanical - 1.6L (LH7) Diesel) >> Repair Instructions - Off Vehicle >> Power Brake Booster Inlet Hose Connector Fitting Removal

Power Brake Booster Inlet Hose Connector Fitting Removal

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Power Brake Booster Inlet Hose Connector Fitting And Components
    GM3216225Courtesy of GENERAL MOTORS COMPANY
  1. Remove the power brake booster inlet hose connector fitting bracket bolt (3) from the exhaust temperature sensor wiring harness bracket (1).
  2. Remove the 2 power brake booster inlet hose connector fitting bolts (4)
  3. Remove the power brake booster inlet hose from the turbocharger wastegate actuator vacuum control solenoid valve (2).
  4. Remove the power brake booster inlet hose connector fitting bolt (7) from the lower crankcase.
  5. Remove the power brake booster inlet hose connector fitting (5).
  6. Remove the power brake booster inlet hose connector fitting seal (6).
scientia non olet · About LEMON Manuals