Conditions for Running the DTC

P0716

• DTC P0101-P0103, P0121-P0123, P0716, P0717, P0752, P0973, P0974 = Not set
• Accelerator Pedal Position Signal from Engine Control Module = Valid
• Engine Speed = 400 to 7, 500 RPM
• Engine Torque Signal = Valid
• Ignition Voltage = 9 to 32 V
• Vehicle Speed = Greater than 10 km/h (6 MPH)

Frequency the DTC runs=Continuously - After the running conditions are met - For greater than 5 s

P0717 Condition 1

• DTC ?P0101-P0103, P0717, P0722, P0723 = Not set
• Calculated Engine Torque=Greater than 50 Nm (37 lb ft)
• Engine Speed= 400 to 7, 500 RPM
• Ignition Voltage= 9 to 32 V
• Vehicle Speed=Greater than 16 km/h (10 MPH) MPH)

Frequency the DTC runs=Continuously - After the running conditions are met - For greater than 5 s

Condition 2

• DTC P0101-P0103, P0717, P0723 = Not set
• DTC P0722 = Test Failed
• Calculated Engine Torque = Greater than 50 Nm (37 lb ft)
• Engine Speed = 400 to 7, 500 RPM
• Ignition Voltage= 9 to 32 V
• Vehicle Speed = Greater than 16 km/h (10 MPH)

Frequency the DTC runs=Continuously - After the running conditions are met

P07BF, P07C0

• DTC P07BF, P07C0 = Not set
• Ignition Voltage= 9 to 32 V

Frequency the DTC runs=Continuously - After the running conditions are met