LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2018 >> Terrain Denali, FWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Mechanical - 1.5L (LYX)) >> Repair Instructions - On Vehicle >> Powertrain Mount Balancing (All Wheel Drive) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Raise the vehicle. Lifting and Jacking the Vehicle
    2. Fig 1: Transmission Mount Strut Bolt
    GM4572779Courtesy of GENERAL MOTORS COMPANY
  2. Loosen the transmission mount strut bolt (2) at the transmission mount strut (3). Transmission Mount Strut Replacement (All Wheel Drive)Transmission Mount Strut Replacement (Front Wheel Drive)
  3. Position two floor jacks with wood blocks under the engine and transaxle in order to support the powertrain assembly.
  4. Lower the vehicle. Lifting and Jacking the Vehicle
    5. Fig 2: Engine Mount Bracket Bolts
    GM4597434Courtesy of GENERAL MOTORS COMPANY
  5. Loosen ONLY the engine mount to engine mount bracket bolts (1). Engine Mount Replacement 
    6. Fig 3: Transmission Mount Bolts And Fastener
    GM4572700Courtesy of GENERAL MOTORS COMPANY
    NOTE:

    Only the transmission mount to transmission bolts should be loosened. Bolts (1) should remain tightened during the balancing procedure.

  6. Loosen ONLY bolts (2) at the left transmission mount (3). Transmission Mount Replacement - Left Side
scientia non olet · About LEMON Manuals