Installation Procedure
WARNING: This page is about a different variant/trim than selected.
- Position the oil deflector (2) then hand start the oil deflector fasteners (1).
- Tighten the fasteners in sequence as shown to 10 N.m (89 lb in).
- Position the positive crankcase ventilation oil separator drain pipe (2) then hand start the fastener (1). Tighten to 10 N.m (89 lb in).
- Install the upper oil pan. Refer to Upper Oil Pan Replacement .
CAUTION:
Refer to Fastener Caution .
NOTE:
Ensure that the retainer (3) is properly installed.
NOTE:
Inspect the seal (4) and install NEW if necessary.