LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2018 >> Terrain Denali, FWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Mechanical - 1.5L (LYX)) >> Repair Instructions - Off Vehicle >> Cylinder Head Cleaning And Inspection >> Camshaft Cap Bore Measurement

Camshaft Cap Bore Measurement

WARNING: This page is about a different variant/trim than selected.
  1. Install the camshaft bearing cap in the cylinder head without the camshaft.
    2. CAUTION:

    Refer to Fastener Caution .

  2. Install the camshaft cap bolts and tighten to 10 N.m (89 lb in).
  3. Measure the camshaft cap bores using an inside micrometer, refer to Engine Mechanical Specifications  for camshaft cap bore diameter.
  4. If camshaft cap bores do not meet specification the cylinder head must be replaced.
scientia non olet · About LEMON Manuals