Reductant Tank Heater
WARNING: This page is about a different variant/trim than selected.
- Ignition Off, disconnect the harness connector at the A38 Reductant Pump and Sensor Assembly.
- Test for 1 - 2 Ω between terminals 9 - 11 at the A38 Reductant Pump and Sensor Assembly.
- If less than 1 Ω or greater than 2 Ω
Replace the A38 Reductant Pump and Sensor Assembly.
- Go to next step: If between 1 - 2 Ω
- If less than 1 Ω or greater than 2 Ω
- Test for infinite resistance between each terminal and the A38 Reductant Pump and Sensor Assembly housing/case.
- If less than infinite resistance
Replace the A38 Reductant Pump and Sensor Assembly.
- Go to next step: If infinite resistance
- If less than infinite resistance
- All OK.
NOTE:
The DMM and test leads must be calibrated to 0 Ω in order to prevent misdiagnosis.