LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2018 >> Terrain Denali, FWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 19 (Engine Controls And Fuel - 1.6L (LH7) Diesel - Diagnostic Information And Procedures (P040B - P204D)) >> Diagnostic Information And Procedures >> DTC P040B, P040C, P040D, P040E, P041B, P041C, P041D, Or P041E: Exhaust Gas Recirculation (EGR) Temperature Sensor 1-2 >> Component Testing

Component Testing

WARNING: This page is about a different variant/trim than selected.
  1. Ignition OFF, disconnect the harness connector at the appropriate B130 Exhaust Gas Recirculation Temperature Sensor.
    2. NOTE:

    The J 25070  may be used to evaluate the sensor under high temperature conditions.

  2. Verify the resistance between the signal circuit terminal 1 and the low reference circuit terminal 2 is within the range specified in the Temperature Versus Resistance (B13 Transmission Fluid Temperature Sensor) Table.
    • If not within the range specified 

      Replace the appropriate B130 Exhaust Gas Recirculation Temperature Sensor.

    • Go to next step: If within the range specified 
  3. Test for infinite resistance between each terminal and the sensor housing/case.
    • If less than infinite resistance 

      Replace the appropriate B130 Exhaust Gas Recirculation Temperature Sensor.

    • Go to next step: If infinite resistance 
  4. All OK
scientia non olet · About LEMON Manuals