Component Testing
WARNING: This page is about a different variant/trim than selected.
Static Test
- Ignition OFF, disconnect the harness connector at the Q47 Exhaust Gas Recirculation Cooler Bypass Solenoid Valve.
- Test for 25 - 35 Ω between the control terminal 1 and the voltage terminal 2 of the Q47 Exhaust Gas Recirculation Cooler Bypass Solenoid Valve.
- If not within 20 - 35 Ω
Replace the Q47 Exhaust Gas Recirculation Cooler Bypass Solenoid Valve.
- Go to next step: If within 20 - 35 Ω
- If not within 20 - 35 Ω
- Test for infinite resistance between each terminal and the Q47 Exhaust Gas Recirculation Cooler Bypass Solenoid Valve housing.
- If less than infinite resistance
Replace the Q47 Exhaust Gas Recirculation Cooler Bypass Solenoid Valve.
- Go to next step: If infinite resistance
- If less than infinite resistance
- All OK.