Induction System Inlet Connection
WARNING: This page is about a different variant/trim than selected.
- Loosen the rear air cleaner outlet duct clamp at the turbocharger compressor inlet.
- Disconnect the rear air cleaner outlet duct from the air cleaner upper housing.
- Use the existing clamp to attach the EN-46091-10A to the air cleaner outlet duct and tighten the clamp securely.
- Tighten the rear air cleaner outlet duct clamp at the turbocharger compressor inlet.
- Attach the safety cable on the EN-46091-10A to a suitable location.