Circuit/System Verification
WARNING: This page is about a different variant/trim than selected.
- Ignition - On / Vehicle - In Service Mode
- Verify there are no DTCs set related to the following system/component:5V Reference
- If any of the DTCs are set
- Go to next step: If none of the DTCs are set
- Verify there are no DTCs set related to the following system/component:B310 Fuel Pressure/Temperature Sensor
- If other DTCs are set - With DTC P0191 set.
Refer to Circuit/System Testing.
- Go to next step: If only DTC P0191 is set & No other DTCs related to the concerned component are set.
Replace the component:B310 Fuel Pressure/Temperature Sensor
- Go to next step: If none of the DTCs are set
- If other DTCs are set - With DTC P0191 set.
- Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
- Verify that no DTCs are set.
- If any of the DTCs are set
Refer to Circuit/System Testing.
- Go to next step: If none of the DTCs are set
- If any of the DTCs are set
- All OK.