LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2018 >> Terrain Denali, FWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 12 (Engine Controls And Fuel - 1.5L (LYX) - Diagnostic Information And Procedures (P0010 - P034B)) >> Diagnostic Information And Procedures >> DTC P0090, P0091, P0092, P00C8, P00C9, Or P00CA: Fuel Pressure Control >> Component Testing

Component Testing

WARNING: This page is about a different variant/trim than selected.
  1. Ignition OFF, disconnect the harness connector at the G18 High Pressure Fuel Pump.
    2. NOTE:

    The DMM and test leads must be calibrated to 0 Ω in order to prevent misdiagnosis.

  2. Test for 1.09 - 1.21 Ω at 20°C (68°F) between the high control circuit terminal 2 and the low control circuit terminal 1.
    • If not between 1.09 - 1.21 Ω 

      Replace the G18 High Pressure Fuel Pump.

    • Go to next step: If between 1.09 - 1.21 Ω 
  3. Test for infinite resistance between each terminal and the G18 High Pressure Fuel Pump housing.
    • If less than infinite resistance 

      Replace the G18 High Pressure Fuel Pump.

    • Go to next step: If infinite resistance 
  4. All OK
scientia non olet · About LEMON Manuals