Fastener Specifications (On Vehicle)
WARNING: This page is about a different car, the 2017 Cadillac ATS. However, it is still accessible from the selected car via links, so may be relevant.
Single Use Non-Threaded Fasteners/Components
|
NOTE:
All fasteners/components listed in this table MUST BE DISCARDED and replaced with NEW after removal. |
|---|
| Application |
| Manual Shaft Shift Pin |
| Manual Shift Shaft Seal |
| Torque Converter Fluid Seal |
Single Use Threaded Fastener/Component Tightening Specifications
|
NOTE:
All fasteners/components listed in this table MUST BE DISCARDED and replaced with NEW after removal. |
|
|---|---|
| Application | Specification |
| Metric (English) | |
| Input Speed Sensor Wiring Harness Bolt | |
|
4 N.m (35 lb in) |
|
45 Degrees |
| Output Speed Sensor Wiring Harness Bolt | |
|
4 N.m (35 lb in) |
|
45 Degrees |
| Torque Converter Bolts | 63 N.m (46 lb ft) |
| Transmission Fluid Baffle Bolts | |
|
4 N.m (35 lb in) |
|
45 Degrees |
Reusable Threaded Fastener Tightening Specifications
|
NOTE:
All fasteners listed in this table can be reused after removal. |
|
|---|---|
| Application | Specification |
| Metric (English) | |
| Automatic Transmission Auxiliary Fluid Accumulator Bolt | 8 N.m (71 lb in) |
| Automatic Transmission Control Indicator Screws | 2.5 N.m (22 lb in) |
| Automatic Transmission Range Selector Lever | 25 N.m (18 lb ft) |
| Auxiliary Heater Pump Bracket to the Transmission | 10 N.m (89 lb in) |
| Flywheel Inspection Cover/Converter Cover Fasteners | 10 N.m (89 lb in) |
| Oil Pressure Test Plug | 11 N.m (97 lb in) |
| Propeller Shaft Transmission Flange Nut | 105 N.m (77 lb ft) |
| Range Selector Lever Cable Bracket | 22 N.m (16 lb ft) |
| Transmission Control Fasteners | 9 N.m (80 lb in) |
| Transmission Fluid Pan Fasteners | 10 N.m (89 lb in) |
| Transmission Heat Shield Fasteners | 9 N.m (80 lb in) |
| Transmission to Engine Bolts | 58 N.m (43 lb ft) |
| Valve Body Assembly Bolts (1, 2) (1 - M6 x 68) and Bolts (2 - M6 x 45) | 9 N.m (80 lb in) |