Ball Check Valve Locations (Gen 3)

I.D.	Input Oil	Input Oil	Output Oil
1	Latch	456 CL	Latch
2	35 Rev CL FD	Drive 1-6	35 Rev CL FD/Drive 1-6
3	35 Rev CL FD/Drive 1-6	-	35 Rev CL FD/Drive 1-6
4	Act FD LM	-	35 Rev CL
5	Drive	-	Drive
6	Line	Auxiliary Line	Line
NOTE: Ball check valve #6 is only required for start/stop transmissions equipped with an auxiliary pump. Ball check valve #6 is optional in non-start/stop transmissions. Ball check valve #6 should NOT be used in start/stop transmissions equipped with an auxiliary accumulator.