Fastener Specifications

Single Use Threaded Fastener/Component Tightening Specifications

NOTE: All fasteners/components listed in this table MUST BE DISCARDED and replaced with NEW after removal.
Application	Specification
Application	Metric (English)
Rear Shock Absorber Bolt@Lower Control Arm	Torque mating fastener
Rear Suspension Adjust Link Bolt
First Pass:	100 N.m (74 lb ft)
Final Pass:	90 - 105 Degrees
Rear Suspension Link Bolt
First Pass:	100 N.m (74 lb ft)
Final Pass:	90 - 105 Degrees
Rear Suspension Link Inner Bolt
First Pass:	100 N.m (74 lb ft)
Final Pass:	90 - 105 Degrees
Rear Suspension Link Outer Bolt
First Pass:	100 N.m (74 lb ft)
Final Pass:	90 - 105 Degrees
Rear Suspension Lower Control Arm Outer Bolt
First Pass:	160 N.m (118 lb ft)
Final Pass:	90 - 105 Degrees
Rear Suspension Trailing Arm Bolt
First Pass:	100 N.m (74 lb ft)
Final Pass:	90 - 105 Degrees
Rear Suspension Upper Control Arm Inner Bolt
First Pass:	100 N.m (74 lb ft)
Final Pass:	90 - 105 Degrees
Rear Suspension Upper Control Arm Outer Bolt
First Pass:	100 N.m (74 lb ft)
Final Pass:	90 - 105 Degrees
Rear Wheel Hub Bolt
First Pass:	100 N.m (74 lb ft)
Final Pass:	15 - 30 Degrees

Reusable Threaded Fastener Tightening Specifications

NOTE: All fasteners listed in this table can be reused after removal.
Application	Specification
Application	Metric (English)
Rear Shock Absorber Bolt@Body	58 N.m (43 lb ft)
Rear Shock Absorber Nut
First Pass:	100 N.m (74 lb ft)
Final Pass:	90 - 105 Degrees
Rear Shock Absorber Shock Rod Mount Nut	25 N.m (18 lb ft)
Rear Stabilizer Shaft Clamp Bolt	58 N.m (43 lb ft)
Rear Stabilizer Shaft Link Bolt	58 N.m (43 lb ft)
Rear Stabilizer Shaft Link Nut	64.5 N.m (48 lb ft)
Rear Suspension Link Inner Nut	100 N.m (74 lb ft)
Rear Suspension Lower Control Arm Inner Nut	160 N.m (118 lb ft)