Front Wheel Bearing and Hub Replacement

Callout	Component Name
Preliminary Procedures Remove the appropriate front wheel speed sensor from the steering knuckle: Front Wheel Speed Sensor Replacement - Left Side Front Wheel Speed Sensor Replacement - Right Side Separate the front wheel drive half shaft from the affected front wheel hub: Front Wheel Drive Half Shaft Replacement - Left Side Front Wheel Drive Half Shaft Replacement - Right Side (AWD) Front Wheel Drive Shaft Replacement - Right Side (FWD) Front Brake Rotor - Remove - Front Brake Rotor Replacement
1	Front Wheel Bearing and Hub Assembly Bolt[3x] CAUTION: This vehicle is equipped with torque-to-yield or single use fasteners. Install a NEW torque-to-yield or single use fastener when installing this component. Failure to replace the torque-to-yield or single use fastener could cause damage to the vehicle or component. CAUTION: Refer to Fastener Caution . Procedure Remove and DISCARD the bolts. Apply thread locking adhesive to the bolt. Adhesives, Fluids, Lubricants, and Sealers Tighten First Pass: 100 N.m (74 lb ft) Final Pass: (65 - 75 degrees)
2	Front Wheel Bearing and Hub Assembly Procedure Apply grease evenly and ensure complete coverage to the steering knuckle bearing pilot bore only. Adhesives, Fluids, Lubricants, and Sealers NOTE: Avoid applying grease to any other machined surfaces, holes, or threads. Ensure the drain channel at the bottom of the bore is not blocked with grease or debris.

Callout

Component Name

Preliminary Procedures

Remove the appropriate front wheel speed sensor from the steering knuckle:
- Front Wheel Speed Sensor Replacement - Left Side
- Front Wheel Speed Sensor Replacement - Right Side
Separate the front wheel drive half shaft from the affected front wheel hub:
Front Brake Rotor - Remove - Front Brake Rotor Replacement

Front Wheel Bearing and Hub Assembly Bolt[3x]

CAUTION:

This vehicle is equipped with torque-to-yield or single use fasteners. Install a NEW torque-to-yield or single use fastener when installing this component. Failure to replace the torque-to-yield or single use fastener could cause damage to the vehicle or component.

CAUTION:

Refer to Fastener Caution .

Procedure

Remove and DISCARD the bolts.
Apply thread locking adhesive to the bolt. Adhesives, Fluids, Lubricants, and Sealers

Tighten

First Pass: 100 N.m (74 lb ft)
Final Pass: (65 - 75 degrees)

Front Wheel Bearing and Hub Assembly
Procedure
Apply grease evenly and ensure complete coverage to the steering knuckle bearing pilot bore only. Adhesives, Fluids, Lubricants, and Sealers

NOTE:

Avoid applying grease to any other machined surfaces, holes, or threads. Ensure the drain channel at the bottom of the bore is not blocked with grease or debris.