Installation Procedure

WARNING: This page is about a different variant/trim than selected.

Courtesy of GENERAL MOTORS COMPANY

Install the crankshaft balancer with NEW fastener. Use EN-51577-1 Crankshaft Balancer Remover (1) and breaker bar (2) prevent the crankshaft from rotating while tightening the NEW crankshaft balancer fastener (3).

CAUTION:

Refer to Fastener Caution .

Tighten the crankshaft balancer bolt to 150 N.m (111 lb ft) plus an additional 140 degrees using the EN-45059 meter.
Install the drive belt. Drive Belt Replacement
Perform the crankshaft position variation learn procedure. Crankshaft Position Variation Learn