Camshaft Position Actuator Intake Solenoid Valve Replacement

WARNING: This page is about a different variant/trim than selected.

Callout	Component Name
Preliminary Procedures Air Cleaner Outlet Front Duct Replacement Intake Manifold Cover Replacement
1	Camshaft Position Actuator Solenoid Valve Bolt CAUTION: Refer to Fastener Caution . Tighten 10 N.m (89 lb in)
2	Camshaft Position Actuator Solenoid Valve - Intake Procedure Disconnect the electrical wiring harness connector from the camshaft position actuator intake solenoid valve. Install a NEW seal if not replacing the solenoid valve.

Callout

Component Name

Preliminary Procedures

Camshaft Position Actuator Solenoid Valve Bolt

CAUTION:

Tighten
10 N.m (89 lb in)

Camshaft Position Actuator Solenoid Valve - Intake

Procedure

Disconnect the electrical wiring harness connector from the camshaft position actuator intake solenoid valve.
Install a NEW seal if not replacing the solenoid valve.