LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2018 >> Acadia Denali, FWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 5 (Automatic Transmission - 6T50 (M2D) - Repair Instructions - On Vehicle) >> Repair Instructions - On Vehicle >> Transmission Rear Mount Replacement (Front Wheel Drive) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Raise and support the vehicle. Lifting and Jacking the Vehicle .
  2. Prior to removing the mount, mark the mount fasteners to mount and mount to sub frame interfaces using spray paint or a marker for correct positioning during installation.
  3. Using a suitable jack stand, support the rear of the powertrain.
  4. GM4290059

    Remove the transmission mount to bracket through bolt (1).

  5. Lower the rear of the drivetrain and front suspension cradle enough the remove the rear mount bolts. Drivetrain and Front Suspension Cradle Removal and Installation (Front Wheel Drive)
    6. NOTE:

    The nuts are reusable.

  6. Remove and DISCARD the rear mount to drivetrain and front suspension cradle bolts (2).
  7. Remove the transmission rear mount
scientia non olet · About LEMON Manuals