LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2018 >> Acadia Denali, FWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 5 (Automatic Transmission - 6T50 (M2D) - Repair Instructions - On Vehicle) >> Repair Instructions - On Vehicle >> Transmission Rear Mount Replacement (Front Wheel Drive) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Using the outline made by the spray paint or marker, position the transmission mount to the drivetrain and front suspension cradle.
  2. GM4290059
    CAUTION:

    Refer to Fastener Caution .

    Install the NEW transmission rear mount bolts (2) and nuts and tighten the bolts to 100 N.m (74 lb ft) plus 95 to 105 degrees.

  3. Install the drivetrain and front suspension cradle to it's original position. Drivetrain and Front Suspension Cradle Removal and Installation (Front Wheel Drive)
  4. Install the transmission mount to bracket through bolt (1) and tighten to 100 N.m (74 lb ft).
  5. Remove the jack stand.
  6. Lower the vehicle.
scientia non olet · About LEMON Manuals