LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2018 >> Acadia Denali, FWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 5 (Automatic Transmission - 6T50 (M2D) - Repair Instructions - On Vehicle) >> Repair Instructions - On Vehicle >> Transmission Mount Replacement - Left Side >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Fig 1: Left Transmission Mount And Transmission Mount To Transmission Bolts (With Tightening Sequence)
    GM4545850Courtesy of GENERAL MOTORS COMPANY

    Install the left transmission mount (5) to the vehicle.

    2. CAUTION:

    Refer to Fastener Caution .

  2. Install the transmission mount to body bolts (4) and tighten to 58 N.m (43 lb ft).
    3. NOTE:

    The left transmission mount to transmission bolts MUST be tightened in sequence.

  3. Install left transmission mount to transmission bolts (3) and tighten in the sequence shown to 100 N.m (74 lb ft).
  4. Position the transmission mount bracket (2) to the vehicle.
  5. Install the transmission mount bracket bolts (1) and tighten to 22 N.m (16 lb ft).
  6. Remove the transmission jack.
  7. Install the battery tray. Battery Tray Replacement
scientia non olet · About LEMON Manuals