LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2018 >> Acadia Denali, FWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 5 (Automatic Transmission - 6T50 (M2D) - Repair Instructions - On Vehicle) >> Repair Instructions - On Vehicle >> Range Selector Lever Cable Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Install the transmission range selector lever cable to the vehicle.
  2. GM4364081

    Install the transmission range selector lever cable grommet (2) to the cowl panel.

    3. CAUTION:

    Refer to Fastener Caution .

  3. Install the grommet fasteners (1) and tighten to 9 N.m (80 lb in).
  4. GM4364012

    Install the transmission range selector lever cable to the transmission control lever base. Insure the cable retainer (1) is fully secured to the transmission control lever base.

    5. WARNING:

    After installing the transmission range selector shift cable, pull up and push down on ALL connections to verify that the connections are fully seated and properly engaged. Failure to perform this task can result in the vehicle not being able to shift into PARK causing potential vehicle damage and bodily injury.

  5. Connect the transmission range selector lever cable terminal (2) to the shift lever pin.
  6. Install the left front floor console extension panel. Front Floor Console Extension Panel Replacement - Left Side
  7. GM4363825

    Install the transmission range selector lever cable (2) to the cable bracket.

  8. Connect the transmission range selector lever cable terminal (1) to the transmission manual shift lever pin.
  9. Adjust the automatic transmission range selector lever cable. Range Selector Lever Cable Adjustment .
  10. Install the battery tray. Battery Tray Replacement
scientia non olet · About LEMON Manuals