Installation Procedure
WARNING: This page is about a different variant/trim than selected.
- NOTE:
Connect the actuator rod (3) to the detent lever assembly.
Install the manual shaft detent (w/shift position switch) lever assembly (4).
- Install the manual shaft (2).
- Install the manual shaft detent lever hub pin (1) using DT-41229
Installer.
Specification
Install the Manual Shaft Detent Lever Hub Pin to height of (b) 7.9 mm (0.38 in).
- Install the NEW manual shift shaft pin (5) using DT-41229
Installer. Use a NEW pin to ensure proper engagement with the case.
Specification
Inspect pin installed height is within (a) 7.2 - 8.2 mm (0.28 - 0.32 in).
- Install the control valve body. Control Valve Body Replacement
- Install the control valve body cover. Control Valve Body Cover Replacement
- Install the automatic transmission range selector lever. Automatic Transmission Range Selector Lever Replacement
Connect the transmission range selector lever cable terminal (1) from the transmission manual shift lever pin.
NOTE:
Lubricate the shaft with automatic transmission fluid to prevent damage to the manual shift shaft seal during installation.
CAUTION:
Use the manual shaft pin installer to install the pin at the correct height in order to properly secure the manual shaft. If you install the pin too deep, the case bore may crack.