LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2018 >> Acadia Denali, FWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 5 (Automatic Transmission - 6T50 (M2D) - Repair Instructions - On Vehicle) >> Repair Instructions - On Vehicle >> Input Speed Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
  1. GM1998841

    Install the 3 input speed sensor seals (1).

  2. Install the input speed sensor (3).
    3. CAUTION:

    Refer to Fastener Caution .

  3. Install the input speed sensor bolt (2) M6 x 23 and tighten to 9 N.m (80 lb in).
  4. GM1998829

    Connect the input speed sensor electrical connector (1).

  5. Install the control solenoid valve and transmission control module assembly. Refer to Control Solenoid Valve and Transmission Control Module Assembly Replacement .
  6. Perform the transmission adaptive values learn procedure. Refer to Transmission Adaptive Values Learn .
scientia non olet · About LEMON Manuals