Fastener Specifications (On Vehicle)
WARNING: This page is about a different variant/trim than selected.
Single Use Non-Threaded Fasteners/Components
|
NOTE:
All fasteners/components listed in this table MUST BE DISCARDED and replaced with NEW after removal. |
|---|
| Application |
| A/Trans Fluid Accumulator Pipe Seal |
| Control Valve Body Cover Wiring Connector Hole Seal |
| Front Wheel Drive Shaft Seal-Left |
| Front Wheel Drive Shaft Seal-Right |
| Input Speed Sensor Assembly Seals |
| Manual Shift Shaft Pin |
| Park Pawl Actuator Guide Assembly Seal |
| Park Pawl Actuator Guide Pin |
Single Use Threaded Fastener/Component Tightening Specifications
|
NOTE:
All fasteners/components listed in this table MUST BE DISCARDED and replaced with NEW after removal. |
|
|---|---|
| Application | Specification |
| Metric (English) | |
| Transmission Rear Mount Bolt | |
|
100 N.m (74 lb ft) |
|
95 - 105 degrees |
| Rear Transmission Mount Bracket to Transmission Bolts (All Wheel Drive) | |
|
100 N.m (74 lb ft) |
|
45 - 60 degrees |
| Rear Transmission Mount Bracket to Transmission Bolts (Front Wheel Drive) | |
|
100 N.m (74 lb ft) |
|
40 - 60 Degrees |
Reusable Threaded Fastener Tightening Specifications
|
NOTE:
All fasteners listed in this table can be reused after removal. |
|
|---|---|
| Application | Specification |
| Metric (English) | |
| A/Trans Auxiliary Fluid Accumulator Bolt (Hybrid Models) | 22 N.m (16 lb ft) |
| A/Trans Auxiliary Fluid Pump Bolt (Hybrid Models) | 22 N.m (16 lb ft) |
| A/Trans Auxiliary Fluid Pump Outlet Bolt (Hybrid Models) | 22 N.m (16 lb ft) |
| A/Trans Auxiliary Fluid Pump (Pump to Motor) Bolt (Hybrid Models) | 10 - 12 N.m (89 - 106 lb in) |
| Control Valve Body to Case Bolt | 11 N.m (97 lb in) |
| Control Valve Body Cover Bolt | 11 N.m (97 lb in) |
| Drain Plug | 12 N.m (106 lb in) |
| Fluid Level Hole Plug | 12 N.m (106 lb in) |
| Fluid Pressure Test Hole Plug | 12 N.m (106 lb in) |
| Front Transmission Mount to Transmission Bolts | 58 N.m (43 lb ft) |
| Front Transmission Mount Through Bolt | 100 N.m (74 lb ft) |
| Input Speed Sensor Bolt | 9 N.m (80 lb in) |
| Left Transmission Mount to Body Bolts | 58 N.m (43 lb ft) |
| Left Transmission Mount Bracket Bolts | 22 N.m (16 lb ft) |
| Left Transmission Mount to Transmission Bolts | 100 N.m (74 lb ft) |
| Manual Shift Detent Spring | 12 N.m (106 lb in) |
| Output Speed Sensor Bolt | 9 N.m (80 lb in) |
| Rear Transmission Mount to Bracket Through Bolt | 100 N.m (74 lb ft) |
| Torque Converter to Flywheel Bolts | 62 N.m (46 lb ft) |
| Transmission to Engine Bolts | 58 N.m (43 lb ft) |
| Transmission Range Selector Cable Bracket | 25 N.m (18 lb ft) |