LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2018 >> Acadia Denali, FWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 15 (Automatic Transmission - 6T50 (M2D) - Repair Instructions - Off Vehicle) >> Repair Instructions - Off Vehicle >> Lift Plate And Holding Fixture Removal

Lift Plate And Holding Fixture Removal

WARNING: This page is about a different variant/trim than selected.
GM1891449
Callout Component Name
1 Transmission Case
WARNING:

Handle with care, the transmission assembly weighs over 83 Kg (183 lbs). Bodily injury could occur if not handled properly.

CAUTION:

Refer to Fastener Caution .

Procedure

  1. Install DT-47811-A  Transmission Lift Plate.
  2. Tighten bolts and nut to 12 N.m (106 lb in).
  3. Remove lock pin from DT-46625  Transmission Holding Fixture.
  4. Raise the transmission with an overhead hoist in order to remove the DT-46625  Transmission Holding Fixture.
  5. Lower the transmission assembly onto the transmission jack in order to remove the DT-47811-A  Transmission Lift Plate.
NOTE:

Only 2 bolt holes on the lift plate will align with the bosses on the transmission case. This is sufficient for lifting the transmission to remove the holding fixture.

Special Tools

  • DT-3289-20  Holding Fixture
  • DT-46625  Transmission Holding Fixture
  • DT-46625-10  Transmission Holding Fixture Adapter
  • DT-47811-A  Transmission Lift Plate

For equivalent regional tools, refer to Special Tools .
scientia non olet · About LEMON Manuals