Control Valve Body Cover Installation

WARNING: This page is about a different variant/trim than selected.

Fig 1: Exploded View Of Control Valve Body Cover Components (With Tightening Sequence)

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
1	Output Speed Sensor Connector
2	Input Speed Sensor Connector
3	Shift Position Switch Connector
4	Control Valve Body Cover Wiring Connector Hole Seal NOTE: Do not re-use the valve body cover wiring connector hole seal.
5	Control Valve Body Cover Gasket NOTE: Do not re-use the valve body cover gasket.
6	Control Valve Body Cover
7	Control Valve Body Cover Bolts M6 x 30 (Qty: 13) CAUTION: Refer to Fastener Caution . Tighten 12 N.m (106 lb in)