Auxiliary Fluid Accumulator Installation

WARNING: This page is about a different variant/trim than selected.

Fig 1: Exploded View Of Auxiliary Fluid Accumulator Components

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
1	Accumulator Bypass Valve Seal NOTE: Install a NEW seal.
2	A/Trans Auxiliary Fluid Accumulator
3	A/Trans Auxiliary Fluid Accumulator Bolt M8 x 30 (Qty: 3) CAUTION: Refer to Fastener Caution . NOTE: Models equipped with a range selector actuator only use (Qty: 2) auxiliary fluid accumulator bolts. Tighten 22 N.m (16 lb ft)
4	A/Trans Fluid Accumulator Pipe Seal (Qty: 2) NOTE: Install NEW seals.
5	A/Trans Fluid Accumulator Pipe
6	A/Trans Auxiliary Fluid Accumulator Bolt M8 x 30 (Qty: 2) Tighten 22 N.m (16 lb ft)
7	A/Trans Auxiliary Fluid Accumulator Solenoid Connector Procedure Connect the connector.