3-5-Reverse And 4-5-6 Clutch Housing, And Input, Reaction, And Output Carrier Installation

WARNING: This page is about a different variant/trim than selected.

Fig 1: Exploded View Of 3-5-Reverse And 4-5-6 Clutch Housing, And Input, Reaction And Output Carrier Components

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
1	3 - 5 Reverse and 4 - 5 - 6 Clutch Housing Thrust Bearing
2	2 - 6 Clutch Apply Plate (Waved)
3	2 - 6 Clutch Plate (Qty: 1) NOTE: Only install one 2 - 6 Clutch Plate. The remaining clutch plate is installed with the gearset assembly. Align the large flat areas with the valve body end of the case and the 2 tabs on the clutch plate that are close to each other with the slots at the bottom right corner of the case.
4	3 - 5 Reverse and 4 - 5 - 6 Clutch Housing Assembly and Gearset NOTE: Align the large flat areas of the 2 - 6 Clutch Plate with the valve body end of the case and the 2 tabs on the clutch plate that are close to each other with the slots at the bottom right corner of the case.