Conditions for Running the DTC
WARNING: This page is about a different variant/trim than selected.
- DTC P0101, P0102, P0103, P0106, P0107, P0108, P0171, P0172, P0174, P0175, P0201, P0202, P0203, P0204, P0205, P0206, P0207, P0208, P0300, P0301, P0302, P0303, P0304, P0305, P0306, P0307, P0308, P0401, P042E, P0716, P0717, P0722, P0723, or P182E is not set.
- Ignition voltage is 9 - 32 V.
- Throttle position signal is valid.
- Engine speed is 400 - 7500 RPM for 5 s.
- High side driver is enabled.
- Transmission fluid temperature is -6.6°C (20°F) or greater.
- Transmission output speed is 100 RPM or greater or the throttle position is 0.5% or greater.
- DTC runs continuously when above conditions are met.