Conditions for Running the DTC
WARNING: This page is about a different variant/trim than selected.
P0722
- DTC P0101, P0102, P0103, P0121, P0122, P0123, P0716, P0717, P0722, or P0723 is not set.
- Ignition voltage is 9 - 32 V.
- Engine speed is 400 - 7500 RPM for 5 s.
- Engine torque signal is valid.
- Throttle position signal is valid.
- Transmission input speed is between 1000 - 8191 RPM.
- Calculated throttle position is 8% or greater.
- Engine torque is 30 N.m (22 lb ft) or greater.
- Transmission fluid temperature is -40°C (-40°F) or greater.
- DTC runs continuously when the above conditions are met.
P0723
- DTC P0101, P0102, P0103, P0121, P0122, P0123, P0723, P0973, P0974, P0976, or P0977 is not set.
- Ignition voltage is 9 - 32 V.
- Greater than 5 s since last transmission upshift or downshift.
- Engine speed is 400 - 7500 RPM for 5 s.
- DTC runs continuously when the above conditions are met.
P077C
- DTC P077D is not set.
- Ignition voltage is 9 - 32 V.
- DTC runs continuously when the above conditions are met.
P077D
- DTC P077C is not set.
- Ignition voltage is 9 - 32 V.
- DTC runs continuously when the above conditions are met.