Conditions for Setting the DTC
WARNING: This page is about a different variant/trim than selected.
P0089
The high pressure fuel pump has exceeded it's control limits. This condition exists when the high pressure fuel pump actuator command is 0° or greater than 240°. The condition exists for greater than 10 s.
P00C6
The ECM detects that the fuel rail pressure is not rising greater than 3 MPa (435 PSI) or has fallen below 2 MPa (290 PSI) during engine cranking, depending on initial pressure when cranking begins.
P228C
The actual fuel rail pressure is 3 MPa (435 PSI) less than the desired fuel rail pressure. The condition exists for greater than 10 s.
P228D
The actual fuel rail pressure is 3 MPa (435 PSI) greater than the desired fuel rail pressure. The condition exists for greater than 10 s.