LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2018 >> Acadia Denali, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 97 (Engine Mechanical - 2.0L (LTG) Or 2.5L (LCV) - Repair Instructions - On Vehicle) >> Repair Instructions - On Vehicle >> Engine Oil Cooler Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2016 Cadillac ATS. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Engine Oil Cooler
    GM2874859Courtesy of GENERAL MOTORS COMPANY
    NOTE:

    A NEW engine oil cooler seal must be used whenever reinstalling the engine oil cooler.

  1. Install the engine oil cooler (1).
    2. Fig 2: Engine Block
    GM4322830Courtesy of GENERAL MOTORS COMPANY
  2. Position the engine oil cooler so that the tab (1) is against the engine block (2).
    3. Fig 3: Engine Oil Cooler Connector
    GM2874857Courtesy of GENERAL MOTORS COMPANY
    CAUTION:

    Refer to Component Fastener Tightening Caution .

  3. Install the engine oil cooler connector (3) and tighten to 50 N.m (37 lb ft).
  4. Install the oil cooler hose (1) and (2).
    5. CAUTION:

    Refer to Fastener Caution .

  5. Install the oil cooler fastener (1) and tighten to 10 N.m (89 lb in)
  6. Engine Mount Bracket-Left Side - Install - Engine Mount Bracket Replacement - Left Side (LCV) , or Engine Mount Bracket Replacement - Left Side (LTG) .
  7. Engine Mout-Left Side - Install - Engine Mount Replacement - Left Side .
  8. Install the engine oil filter. Refer to Engine Oil and Oil Filter Replacement .
scientia non olet · About LEMON Manuals