LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2018 >> Acadia Denali, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 97 (Engine Mechanical - 2.0L (LTG) Or 2.5L (LCV) - Repair Instructions - On Vehicle) >> Repair Instructions - On Vehicle >> Engine Front Cover Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2016 Cadillac ATS. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the camshaft cover. Camshaft Cover Replacement 
    2. Fig 1: Crankshaft Balancer
    GM2831024Courtesy of GENERAL MOTORS COMPANY
  2. Remove the crankshaft balancer (1). Crankshaft Balancer Replacement (Except North America) Crankshaft Balancer Replacement 
    3. Fig 2: Drive Belt Tensioner
    GM2831023Courtesy of GENERAL MOTORS COMPANY
  3. Remove the drive belt tensioner (1). Drive Belt Tensioner Replacement 
  4. Disconnect the wire harness retainers from the front cover.
    5. Fig 3: Identifying Engine Front Cover Bolts
    GM4038928Courtesy of GENERAL MOTORS COMPANY
    NOTE:

    Only bolts 3, 5 and 6 will be replaced with NEW bolts.

  5. Engine Front Cover Bolt- Remove and DISCARD 3, 5 and 6
  6. Engine Front Cover Bolts - Remove
  7. Engine Front Cover (1) Remove
  8. If reusing the engine front cover, remove and DISCARD the crankshaft front oil seal (8) using an appropriate tool.
  9. Clean the engine block and cylinder head to front cover sealing surfaces.
  10. Clean the front cover sealing surface.
scientia non olet · About LEMON Manuals