LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2018 >> Acadia Denali, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 97 (Engine Mechanical - 2.0L (LTG) Or 2.5L (LCV) - Repair Instructions - On Vehicle) >> Repair Instructions - On Vehicle >> Crankshaft Balancer Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2016 Cadillac ATS. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Crankshaft Balancer Remover
    GM3971349Courtesy of GENERAL MOTORS COMPANY
  1. Install the crankshaft balancer with NEW fastener. Use EN-51577-1   Crankshaft Balancer Remover (1) and breaker bar (2) prevent the crankshaft from rotating while tightening the NEW crankshaft balancer fastener (3).
    2. CAUTION:

    Refer to Fastener Caution .

  2. Tighten the crankshaft balancer bolt to 150 N.m (111 lb ft) plus an additional 140 degrees using the EN-45059   meter.
  3. Install the drive belt. Drive Belt Replacement 
scientia non olet · About LEMON Manuals