Camshaft Cover Heat Shield Replacement (LTG)

WARNING: This page is about a different car, the 2016 Cadillac ATS. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Camshaft Cover Heat Shield (LTG)

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
Preliminary Procedures Intake Manifold Cover Replacement Turbocharger Heat Shield Replacement
1	Camshaft Heat Shield Cover Fastener (Qty: 4) CAUTION: Refer to Fastener Caution . Tighten 10 N.m (89 lb in)
2	Camshaft Heat Shield Cover Procedure Disconnect the camshaft position actuator solenoid valve. Unclip the wiring harness. NOTE: When removing the camshaft cover heat shield, carefully guide the shield past the turbocharger coolant return and PCV pipes.

Callout

Component Name

Preliminary Procedures

Intake Manifold Cover Replacement
Turbocharger Heat Shield Replacement

Camshaft Heat Shield Cover Fastener (Qty: 4)

CAUTION:

Refer to Fastener Caution .

Tighten
10 N.m (89 lb in)

Camshaft Heat Shield Cover

Procedure

Disconnect the camshaft position actuator solenoid valve.
Unclip the wiring harness.

NOTE:

When removing the camshaft cover heat shield, carefully guide the shield past the turbocharger coolant return and PCV pipes.