Water Pump Installation (LGX)

WARNING: This page is about a different car, the 2016 Cadillac ATS. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Water Pump (LGX)

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
1	Water Pump Gasket NOTE: Install a NEW gasket.
2	Water Pump Locating Pin
3	Water Pump
4	Engine Front Cover Bolt CAUTION: Refer to Fastener Caution . Tighten in sequence 15 N.m (11 lb ft)
5	Water Pump Bolt CAUTION: This vehicle is equipped with torque-to-yield or single use fasteners. Install a NEW torque-to-yield or single use fastener when installing this component. Failure to replace the torque-to-yield or single use fastener could cause damage to the vehicle or component. NOTE: Install NEW bolts. Tighten in sequence 15 N.m (11 lb ft)
6	Water Pump Pulley Procedure Install the EN-46104 Water Pump Pulley Holding Tool onto the water pump pulley mounting holes. Install the water pump pulley bolts. Remove the EN-46104 Water Pump Pulley Holding Tool from the water pump pulley. Special Tools EN-46104 Water Pump Pulley Holding Tool For equivalent regional tools, refer to Special Tools (LGX)Special Tools (LF4) .
7	Water Pump Pulley Bolt Tighten 10 N.m (89 lb in)