Oil Pan Installation (LF4)

WARNING: This page is about a different car, the 2016 Cadillac ATS. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Engine Oil Pan

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
1	RTV Sealant Procedure Ensure proper use of room temperature vulcanizing (RTV) sealant. Use of Room Temperature Vulcanizing (RTV) and Anaerobic Sealant Place a 3 mm (0.118 in) bead of RTV sealant on the block pan rail and the crankshaft rear oil seal housing (1). Refer to Adhesives, Fluids, Lubricants, and Sealers (LF4)Adhesives, Fluids, Lubricants, and Sealers (LGX) for recommended sealant.
2	Oil Pan
3	Oil Pan Bolts - Medium CAUTION: Refer to Fastener Caution . NOTE: Tighten the oil pan bolts in sequence shown. Tighten 10 N.m (89 lb in)
4	Oil Pan Bolt - Long NOTE: Tighten the oil pan bolts in sequence shown. Tighten 10 N.m (89 lb in)
5	Oil Pan Bolt - Short NOTE: Tighten the oil pan bolts in sequence shown. Tighten 25 N.m (18 lb ft)